in the previous post about these single player maps, i requested help on switching the bsp during game play, which worked fine for 2-4 sections of Assault on the Control Room, but unfortunately i cannot seem to locate one of the bsp files. its far into the section with no enemies or anything, just map, directly after you exit the tunnels and enter the canyon with the sideways arrow shaped base. (or bsp_12.)

i think switch_bsp 13 or 14 makes something show up, but its very far away. +i can drive on this gray area, which in previous altercations, was much more wall like. i usually hit what i assume is an actual wall in the map, but its impossible to tell.

(-)flycam wont work, even the cmt flycam in the cmt extras section of the in game menu fails to respond. is there any way i can just skip the map ?_?

BSP 12 isn't the one you have to go through. Go back to where you were in the tunnels, and start switching BSPs from 0 until 11, then 13 to whatever.

From there, you can continue the level normally.

Just create a checkpoint and do some trial and error. I believe there is more than 11 BSPs, though.

Switch_BSP #
Edited by pepzee on Jul 8, 2011 at 12:07 PM

He was looking for the BSP after the last tunnel where you have the Scorpion, not after the bridge.

I believe it's switch_bsp 5, but I haven't played the CMT campaign in a while, which is why I suggested you go through all the BSPs (except for 12) until you get to where you need to go.

ube chief- i shall try all the bsps except 12 :)